2-Pack Epoxy Resin Floor Coating Paint Garage Concrete W702 2,5-20Kg
- 49,90€
54,90€- 49,90€
- Unit price
approx. 250 g/m²Consumption
60–90 Min.Pot life
+15 bis +25 °CApplication temperature
How much do I need?
Required amount:
--
The calculated amount is a guide. Actual consumption depends greatly on the substrate.
Already thought about the right accessories?
-
Pre-cleaner for Concrete Garage Pool Substrate Preparation surface Before Painting Cleansing Effect W810 5-10L
22,90€
-
Acid Etching surface Preparation for better adhesion of W700 Floor coating paint for concrete and for W702 2-Pack Epoxy Resin Floor Coating Paint Garage Concrete W800 - 10L
29,90€
-
2-Pack Epoxy Resin Mortar Grout Paving Joint Concrete Repair Mortar W757 - 5-20Kg
49,90€
-
Special Floor Primer for Epoxy Preparation W703 - 1-10kg
19,90€
-
2-Pack Epoxy Resin Floor Sealer Floor Concrete Clear/Colorless W734 1,5-20Kg
34,90€
-
Decorative Epoxy Resin Color Chips Flakes for Garage Floor Coating 0.5-5Kg
19,90€
Description
- 2-component epoxy resin floor coating + hardener
- Consumption is strongly dependent on the absorbency of the substrate
- Epoxy for mineral surfaces e.g. concrete, cement and screed, also for hard asphalt screed and fiberglass
- W702 2 components floor paint creates a silk-gloss and easy-care surface
- Easy to use / Water-based / Low odor
- Good durable and impact / abrasion resistant load capacity even on trafficked industrial floors
- 2-pack epoxy resin floor paint has excellent chemical resistance for floor
- Solvent-free, environmentally friendly epoxy resin coating for interior use
- Application area: garage, workshop, basement, warehouse, industrial hall, covered parking lot and more.
- Consumption: approx. 200-300g / m2 per coat; 5kg up to 25m2 l 10kg up to 50m2 l 20kg up to 100m2
Product data
Product description
2-Pack epoxy resin floor coating from WO-WE is an ideal coating for concrete, cement floors indoors. W702 coating is extremely abrasion resistant, scratch resistant and easy to clean. In addition, the garage floor / industrial floor is protected against various chemicals, oil, road salt and dirt. The mechanical resistance is mainly determined by the strength of the substrate. Due to the low layer thickness, there is a risk of damage to the sealing film in case of stronger mechanical stress, therefore it is always recommended to apply 2 coats.Our 2-Pack epoxy coating is satin gloss. For the MATT finish, we recommend the W702 Epoxy Resin Floor Coating Paint Garage Concrete. For the last coat, Epoxy Sealer W734 Colorless floor protector for concrete is recommended, but BE CAREFUL!!! it gives the SHINY aspect to your surface.
Operation area: General industry, steel construction, heavy corrosion protection, agriculture, production halls, warehouses, basements, balconies, carports, parking decks and many more.
Consumption: approx. 200-300g/m2
PLEASE NOTE!!! THE CONSUMPTION IS STRONGLY DEPENDENT ON THE ABSORBENCY OF THE SUBSTRATE
Surface preparation
Check substrate and adhesion for suitability, remove loose pieces. The substrate must be load-bearing, clean, dry, grease-free and solid. First completely remove dirt, cement slurry, oxide layers, lime deposits or separating agents with W810 Special Pre-Cleaner and wash thoroughly. Heavily soiled, oil-contaminated or new concrete or screed surfaces must be additionally pretreated with W800 Etching solution First repair any cracks and holes with W757 – 2-Pack epoxy resin mortar. Level unwanted unevenness and slopes with W715 - Levelling Compound.Processing
Mix the material in the correct mixing ratio (colored: 10:1 / clear 2:1) FIRST IMMEDIATELY BEFORE PROCESSING. To do this, first stir the base compound, then add hardener and mix intensively at max. 450 rpm with a slow-running agitator or drill with stirring paddle until a streak-free and uniform color shade is obtained. Transfer material to another container (repot) and mix thoroughly again (do not process from the delivery container). Always work fresh in fresh for a uniform appearance. When rolling, apply the material evenly and re-roll in a cross patternRecommended additional products
Product information
2-pack water-based epoxy resin is a highly abrasion-resistant, chemical-resistant 2-pack floor coating for interior use. For coating garages, basements, living rooms, offices and rooms with higher loads.
Hazard statements
2-Pack Epoxy Resin Coating (Com-A)
The product complies with the requirements of EU Directive 2004/42/EC on the limitation of VOC content.
2-Pack Epoxy Resin Coating (Com-B)
Causes severe eye damage
Keep out of reach of children / Wear protective gloves / protective clothing / eye protection / face protection / In case of contact with eyes: Rinse cautiously with water for several minutes. Remove any contact lenses if possible. Continue to rinse / In case of skin irritation or rash: seek medical advice / seek medical attention / If eye irritation persists: seek medical advice / seek medical attention / Dispose of contents / container to an appropriate recycling or disposal facility
The product complies with the requirements of EU Directive 2004/42/EC on the limitation of VOC content.
