Product description
2-Pack epoxy resin floor coating from WO-WE is an ideal coating for indoor concrete and cement floors. Our 2-Pack floor coating is extremely abrasion-resistant, scratch-resistant and easy to clean. In addition, the garage floor / industrial floor is protected from various chemicals, oil, road salt and dirt. The mechanical resistance is mainly determined by the strength of the substrate. Due to the small layer thickness, there is a risk of damage to the sealing film in the event of greater mechanical stress,
so it is always advisable to apply 2 coats.
Our 2-Pack epoxy resin coating is MAT. For the SHINY finish, we recommend W702 Epoxy Resin Floor Coating Paint SHINY.
For the last coat, Epoxy Sealer W734 Colorless floor protector for concrete is recommended, but BE CAREFUL!!! it gives the SHINY aspect to your surface.
Area of application: General industry, steel construction, heavy corrosion protection, agriculture, production halls, warehouses, basements, balconies, carports, parking decks and much more.
Consumption: approx. 200-300g/m2
PLEASE NOTE!!! CONSUMPTION DEPENDS STRONGLY ON THE ABSORBENCY OF THE SUBSTRATE
Surface preparation
Check substrate and adhesion for suitability, remove loose pieces. The substrate must be stable, clean, dry, free of grease and firm. First remove dirt, cement sludge, oxide layers, lime deposits or release agents with
Pre-cleaner for Concrete Garage Pool Substrate Preparation surface Before Painting Cleansing Effect W810
remove completely and wash thoroughly. Heavily soiled, oil-soiled or new concrete or screed surfaces must also be treated with
Acid Etching surface Preparation for better adhesion of W700 Floor coating paint for concrete and for W702 2-Pack Epoxy Resin Floor Coating Paint Garage Concrete W800.
Treat holes first with 2-Pack Epoxy Resin Mortar Grout Paving Joint Concrete Repair Mortar W757 and bumps or slopes with Floor leveling compound Smooth Level surface Preparation Coverings Cementitious mixture Mortar Grout W715.
Processing
Mix the material ONLY IMMEDIATELY BEFORE PROCESSING in the correct mixing ratio (colored: 10:1 / clear 2:1). First stir up the base material, then add the hardener and mix it in with a slow-running stirrer or drill Mix intensively with an agitator at max. 450 rpm until a streak-free and even color is obtained. Pour the material into another container (repot) and mix thoroughly again (do not use from the delivery container). For an even look, always work fresh on fresh. When rolling, apply the material evenly and roll crosswise.
Recommended additional products
W702 –Epoxy Resin Floor Coating Paint Garage Concrete SHINY
W703 – Special Floor Primer for Epoxy Preparation
W733 – 2-Pack Epoxy Resin Primer Adhesive Primer Coating Adhesive Deep Primer
W757 – 2-Pack Epoxy Resin Mortar Grout Paving Joint Concrete Repair Mortar
W758 – Silicate-based anti-slip agent
W800 – etching solution
W810 – Pre-cleaner for Concrete Garage Pool Substrate Preparation surface Before Painting Cleansing Effect
2-Pack water-based epoxy resin is a highly abrasion-resistant, chemical-resistant 2-Pack interior floor coating. For coating garages, cellars, living and office rooms as well as rooms with higher loads.
2-Pack floor coating (component A)
This product complies with the requirements of Directives 2004/42/EC and 2010/79/EU on the limitation of VOC content.
2-Pack floor coating (component B)
Causes serious eye damage
Keep out of reach of children / Wear protective gloves / protective clothing / eye protection / face protection / IF IN EYES: Rinse cautiously with water for several minutes. If possible, remove contact lenses. Continue rinsing / If skin irritation or rash occurs: Get medical advice/ attention / If eye irritation persists: Get medical advice/ attention / Dispose of contents/container to an appropriate recycling or disposal facility
This product complies with the requirements of Directives 2004/42/EC and 2010/79/EU on the limitation of VOC content.
